Difference between revisions of "Rear Axle/Differential R&R"

From Eaglepedia
Jump to: navigation, search
 
(One intermediate revision by one other user not shown)
Line 19: Line 19:
  
 
3.- Drain the axle housing. Place oil pan under differential, loosen differential cover bolts and remove bottom 2 bolts.
 
3.- Drain the axle housing. Place oil pan under differential, loosen differential cover bolts and remove bottom 2 bolts.
 
4.- Remove the axle cover -see picture below.
 
  
 
[[Image:yellowdifferentialcover.jpg|frame|Differential Cover is in Yellow|left]]
 
[[Image:yellowdifferentialcover.jpg|frame|Differential Cover is in Yellow|left]]
Line 56: Line 54:
  
  
 +
 +
 +
 +
4.- Remove the axle cover - see image above.
  
 
5.- Remove the wheels, brake drums, hubs, axel shaft and seals. Keep the axel parts separated according to the side of the vehicle from which they were removed.
 
5.- Remove the wheels, brake drums, hubs, axel shaft and seals. Keep the axel parts separated according to the side of the vehicle from which they were removed.

Latest revision as of 22:17, 21 July 2006

1980-1983 AMC Eagle's

The Differential repair requires special skills and specialty tools.

The inspection procedures will tell if repairs are necessary.


Rear Axle Differetial/Removal/Installation:

http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure13.jpg

The differential can be checked and overhauled without removing the rear axle assembly.

Refer to Figure 13 for part names and location.

1.- Remove the axle shaft dust caps. Lossen the wheel nuts.

2.- Raise the rear of the vehicle and place it on jackstands.

3.- Drain the axle housing. Place oil pan under differential, loosen differential cover bolts and remove bottom 2 bolts.

Differential Cover is in Yellow



















4.- Remove the axle cover - see image above.

5.- Remove the wheels, brake drums, hubs, axel shaft and seals. Keep the axel parts separated according to the side of the vehicle from which they were removed.

6.- Mark the bearing caps with a centerpunch for reassembly reference.

7.- Loosen the bearing cap bolts until only a few threads remain engaged. Pull caps away from bearings. This will prevent the differential assembly from falling out in set 8.

8.- Pry the differential loose in the axle housing with a pry bar.

9.- Remove the bearing caps. remove the differential assembly.

10.- Tie the bearing shims to their respective caps and cups to prevent them from being mixed up or misplaced.

11.- Installation is the reverse of removal. tighten all fasteners to specifications.

http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialtable1.jpg