Difference between revisions of "Rear Axle/Differential R&R"

From Eaglepedia
Jump to: navigation, search
Line 19: Line 19:
  
 
3.- Drain the axle housing. Place oil pan under differential, loosen differential cover bolts and remove bottom 2 bolts.
 
3.- Drain the axle housing. Place oil pan under differential, loosen differential cover bolts and remove bottom 2 bolts.
 
4.- Remove the axle cover -see picture below.
 
  
 
[[Image:yellowdifferentialcover.jpg|frame|Differential Cover is in Yellow|left]]
 
[[Image:yellowdifferentialcover.jpg|frame|Differential Cover is in Yellow|left]]
Line 53: Line 51:
  
  
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
4.- Remove the axle cover.
  
  

Revision as of 22:14, 21 July 2006

1980-1983 AMC Eagle's

The Differential repair requires special skills and specialty tools.

The inspection procedures will tell if repairs are necessary.


Rear Axle Differetial/Removal/Installation:

http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure13.jpg

The differential can be checked and overhauled without removing the rear axle assembly.

Refer to Figure 13 for part names and location.

1.- Remove the axle shaft dust caps. Lossen the wheel nuts.

2.- Raise the rear of the vehicle and place it on jackstands.

3.- Drain the axle housing. Place oil pan under differential, loosen differential cover bolts and remove bottom 2 bolts.

Differential Cover is in Yellow




















4.- Remove the axle cover.



5.- Remove the wheels, brake drums, hubs, axel shaft and seals. Keep the axel parts separated according to the side of the vehicle from which they were removed.

6.- Mark the bearing caps with a centerpunch for reassembly reference.

7.- Loosen the bearing cap bolts until only a few threads remain engaged. Pull caps away from bearings. This will prevent the differential assembly from falling out in set 8.

8.- Pry the differential loose in the axle housing with a pry bar.

9.- Remove the bearing caps. remove the differential assembly.

10.- Tie the bearing shims to their respective caps and cups to prevent them from being mixed up or misplaced.

11.- Installation is the reverse of removal. tighten all fasteners to specifications.

http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialtable1.jpg