DIFFERENTIAL INSPECTION: In Axle Housing

From Eaglepedia
Revision as of 05:01, 21 July 2006 by GilSX4 (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
Front Differential

1.- Mount a dial indicator on the housin as shown in Figure 24

http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure24.jpg

to measure ring gear backlash. The indicator plunger should touch the drive side of a ring gear tooth at the right angles to the tooth. Hold the pinion from turning with one hand and rotate the ring gear against the dial indicator with the other. Backlash should be 0.005 - 0.010 in. (0.12 - 0.25 mm). If not, have the differential disassembled and adjusted.

2.- Measure ring gear runout. It should not exceed o.006 in. (0.15 mm). If it dose, have the differential repaired.



Rear Differential

http://i58.photobucket.com/albums/g242/trapperjack/eaglerear001.jpg

1.- Mount a dial indicator on the housing as shown in Figure 25

http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure25.jpg

to measure ring gear backlash. the indicator plunger should touch the drive side of a ring gear tooth at right angles to the the tooth. Hold the pinion from turning with one hand and rotate the ring gear against the dial indicator with the other. Backlash should be 0.005 - 0.009 in. (0.12 - 0.22 mm), with 0.008 in. (0.20 mm) desired. If not have the differential disassembled and adjusted.

2.- Remount the dial indicator as shown in Figure 26

http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialfigure26.jpg

to measure ring gear runout. It should not exceed 0.002 in. (0.05 mm). If it does, have the differential repaired.


TIGHTENING TORQUES

http://img.photobucket.com/albums/v198/Gilspix/AMC%20Diagrams/Differentialtable1.jpg