Difference between revisions of "Correctly setting your idle speed 1980 - 1988"

From Eaglepedia
Jump to: navigation, search
Line 32: Line 32:
  
 
[[Image:idleadjustC.jpg|right]]   
 
[[Image:idleadjustC.jpg|right]]   
 +
 +
 +
  
  
Line 41: Line 44:
  
 
5.  Diconnect the 4-in. and 10-in. Hg vacuum switch assebly wire connector located adjacent to the vacuuum switch assembly (Figure C).
 
5.  Diconnect the 4-in. and 10-in. Hg vacuum switch assebly wire connector located adjacent to the vacuuum switch assembly (Figure C).
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
 +
  
  

Revision as of 15:11, 29 January 2006

Under Construction


From the AMC Technical Service Bulletin 12E460

The idle speed may be too low or inconsistent on your 1980 - 1988 Eagle automobile. If this condition exists, the following items must be adjusted to obtain proper engine operation.

Ignition Timing

Fast Idle Speed

Curb Idle Speed

Sole-Vac Throttle Postioner


Adjustment is as Follows:

1. The engine must be at operating temperature and all electrical accessory switches in the OFF position.

2. Remove the air filter assembly -- make sure to mark where any vacuum hoses connected.

3. Set the parking brake or better yet block the wheels. Shift automatic transmissions to PARK and manual transmissions to the NEUTRAL position.

4. With the ignition switch OFF, connect an ignition timing light to the number 1 spark plug (Figure A) and tachometer to the coil ignition negative terminal (Figure B).


Figure AIdleadjustB.jpg Figure BIdleadjustA.jpg



IdleadjustC.jpg






5. Diconnect the 4-in. and 10-in. Hg vacuum switch assebly wire connector located adjacent to the vacuuum switch assembly (Figure C).















Under Construction